⚡

Inventopia

Inventopia (2022 - present / Davis CA)

Product Developer Intern

  • Set up a “Project Requirements” document to organize & guide project
  • Programmed and deesigned a circuit using the arduino IDE, adafruit components, soldering, & a breadboard
  • Used Fusion 360 to map out the geometry of product constraints
  • Assembled a product protoype using 3D printing and the circuit I designed
Here is the back side of the prototype showing the wriring that is meant to be covered up.
Here is the back side of the prototype showing the wriring that is meant to be covered up.
Here is the side of the prototype. You can see the steerable light module as well as the buttons.
Here is the side of the prototype. You can see the steerable light module as well as the buttons.

LinkedInYouTubeGitHubInstagramTwitter